This Coconut Creek install put a 55-inch TV somewhere most mounts never go: directly above a doorway. Not a fireplace, not open wall space — the header above a door opening, with a tilt mount and full in-wall cable concealment making it work.
The wall above a door isn't framed like the rest of the wall
A normal wall has studs running the full height at a regular 16 or 24-inch spacing, so finding one is usually just a matter of running a stud finder across the surface. A doorway breaks that pattern entirely. The opening itself is framed with king studs — full-height studs on either side of the door — and jack studs underneath a header, a horizontal beam that carries the load the door opening interrupts. This mount sits low, right against the top of the door casing, which puts it directly in header territory rather than up in the cripple-stud zone above — and the header, solid framing lumber running the full width of the door, is actually one of the better anchor points on the wall once you know it's there. Mounting this close to the frame isn't a compromise; it's what let the header do the work instead of hunting for a stud that isn't in its usual spot.
Why tilt, not fixed, at this height
A TV mounted above a door sits well above normal eye level for anyone standing or seated nearby, and mounting it flush to the wall at that height points the screen straight out — fine for someone standing directly below it, uncomfortable for anyone viewing from a normal seated distance across the room. THX's own guidance keeps the viewing angle within about 15 degrees of the screen's center before image quality and comfort both suffer; a TV sitting roughly 10 inches above eye level at a typical 8-foot viewing distance needs on the order of 5-6 degrees of downward tilt to land back inside that window. A fixed mount can't correct for that after the fact — the tilt has to be built into the mount itself, dialed in once the TV's actually up and the real viewing angle is known, not guessed at on paper beforehand.
Routing cable around a beam that's directly in the way
With the TV mounted right at header height, that same beam sits directly in the path a straight vertical cable run would normally take. A header spans solid across the full width of the door opening, so there's no fishing a cable through it — the run has to detour around it, through the king stud bay to one side, before it can continue down toward a power source. We map exactly where that beam starts and ends before pulling any cable, rather than fishing blind and hitting solid wood partway down.
The result: a 55-inch TV holding securely above a doorway most installers would pass on, tilted to correct the viewing angle the placement created, with cables routed around the door's framing instead of through it.
Have an unusual spot you want a TV mounted — above a door, an angled wall, anywhere a standard install wouldn't work — in Coconut Creek or anywhere in South Florida? Hero TV Mount figures out the framing first — call or text (754) 340-1000 to schedule.
