This Weston, FL job called for a 50-inch TV with full in-wall cable concealment — a mid-size screen that's easy to under-mount if you don't check the panel's spec sheet before picking a bracket.
Matching the bracket to a 50-inch panel
A 50-inch TV isn't a fixed spec — depending on the model, the back panel uses a VESA 200x200mm or 300x300mm mounting hole pattern, and the set itself typically runs somewhere in the 20-35 lb range. Before anything goes on the wall, we confirm the VESA spacing against the mount plate and check that the bracket's rated weight capacity clears the panel's actual weight with margin, not just "close enough."
Reading the wall before drilling
Weston is largely CBS (concrete block stucco) construction, but that doesn't mean every wall in the house is block — exterior and load-bearing walls are typically masonry, while interior partition walls are framed like anywhere else. In this case the wall behind the TV turned out to be an interior drywall partition, so the install used standard stud-anchored hardware rather than masonry anchors. We probe the wall first rather than assume, since guessing wrong means pulling a mount back off a wall that's already been drilled.
Routing power around code, not through it
Low-voltage cabling (HDMI, any streaming-box lines) runs through the wall cavity via fish tape. Power is the part that can't just get pushed through — a standard extension cord isn't rated to run inside a wall cavity under fire code, so the fix is an in-wall power relocation kit: two low-profile outlets, one behind the TV and one at the original outlet location, connected through the wall by a cable built for exactly that. The TV plugs in directly behind itself, with nothing dropping to the floor or routed through an external raceway.
The result: a 50-inch TV mounted level and secure on hardware matched to its actual VESA pattern and weight, with power and video cable both fully concealed inside the wall.
Looking for TV mounting with hidden cables in Weston or anywhere in South Florida? Hero TV Mount handles both the mount and the wiring — call or text (754) 340-1000 to schedule.
